powoq Side Bed Panel for Silverado & Sierra Install Breakdown

If you’re looking to make better use of the empty space in your truck bed, installing a Bed Side MOLLE Panel is a great way to go.

It keeps your gear organized and easily accessible. Even better, our Side MOLLE Panel mounts directly to the existing factory points—meaning zero drilling or modifications to your truck.

Overview of Installation

• First, locate the three oval-shaped rubber covers situated above the wheel well on the inner side of the truck bed. Pop these three covers out to reveal the slots. Next, take the provided brackets and secure them into the three exposed slots.
• With the brackets in place, lift the first panel and align it with the mounting holes on the brackets. Insert the screws into the three mounting holes to hold the panel in place. However, do not fully tighten them yet.
• Then, use the provided side bracket to secure the side of the panel to the factory D-ring tie-down. Again, leave the hardware slightly loose.
• Repeat the above steps to install and secure the second panel.
• Finally, secure the two panels together using the connecting piece. Once everything is perfectly aligned and flush, go ahead and tighten down all the bolts to lock it in place.

The Final Result

Once everything is bolted down, you’ll have a secure and functional space to mount your tools, recovery gear, and tie-downs without taking up precious floor space in the bed.